Sonya Awning April 25th, 2018 - 08:35:42
Here are a few helpful tips for installations: Always attach retractable awning mounting brackets to a load-bearing part of the building, like a stud, joist, rafter, brick, or beam, depending on the mounting option. Use a chalk line and level. Its just easier than trying to eyeball whether the awning or screen is even. Because of the weight of the awning and to keep everything properly positioned, have two people working on the retractable awning installation. Read the instructions in the kit or on the companys website. When in doubt, call the manufacturers customer service line.In a decent afternoon of work, you can have a lovely retractable awning or drop screen installed over a patio, garden, eating area, walkway - wherever you want to make a pleasing, comfortably shaded haven.
Why is the awning being used? Figure out clearly why that area needs protection and what element you want to control. The requirements for the awning are different for rain protection and sun protection. For example, to use the awning in wet areas, have at least a 3 inch slope, or pitch, to the awning per foot of extension. If an awning extends 12 feet, the pitch should be 36 inches, meaning that the awning must be mounted 3 feet higher than the height at the end of the awning fully extended. Awnings in sunny locations with little can be nearly flat. For other situations, awnings may not be ideal; high, sustained winds can seriously damage awnings, as can the weight from snow, ice, and hail. Accessories like wind or motion sensors can also be used to protect the retractable awning in less than ideal conditions.
One important note for drop screens: not every manufacturer has a do-it-yourself style, so make sure you dont need a contractor before ordering the screen. A retractable awning installation is slightly more complicated than a screen installation, so follow the manufacturers instructions:1. Locate the bricks, rafters, studs, or joists to which to mount the awning.2. Install a pressure-treated board at the install location if mounting onto siding. It is extremely important that the awning be mounted on a flat, level surface, which isnt always possible with siding, shingles, and brick. 3. Install the mounting brackets, with the end brackets about three inches inside the edge of the awning and the other brackets evenly spaced between them. The number of mounting brackets depends on the width and projection of the specific retractable awning. 4. Install and attach the optional hood about 1 inch above awning location. 5. Lift the retractable awning, and insert it in the mounting brackets.6. Tighten the retaining bolts.
Also, retractable awnings have financial benefits over fixed awnings that make them a tempting solution: Retractable awnings are overall less expensive than fixed awnings to install, and they dont require a contractor. Retractable awnings are about a quarter to a third of the cost of permanent construction to cover and utilize the same square footage. Because many styles of retractable awning arms are spring-loaded, there are no support posts to install, to block the view from under the awning, or to act as a potential hazard for children and pets. They require virtually no maintenance, not even mandatory cleaning.Capital Improvement Advantage Retractable awnings have interesting ways of saving a business money: o Direct energy cost savings. Sun protection systems cut heat buildup in a room as much as 77%, translating into a direct utility bill savings of up to 25%. "Dual use" as signage and promotion. Business names, logos, and telephone numbers can be printed on the awning, which saves money on constructing and designing separate signs.