Sonya Awning April 25th, 2018 - 08:33:08
How much shade coverage is required. What the width of the awning should be, based on the shade area. Add at least 12 inches to maximize coverage for sun and rain protection. How far out the awning extends (the projection), based on the shade area. There is a natural slope to an awning, so the actual shade is several inches shorter than the full projection. How high to mount the awning. Because of the awnings slope, the front of the awning is lower than the mounting position; this difference is the drop. The recommended drop is 3 inches per foot of projection. So, if the awning has a 12-foot projection, the drop is about 36 inches. To get a 7-foot clearance under the front bar, the awning has to be mounted at least 10 feet high. Scout out a mounting place that is free of obstructions (no lights, gutters, wiring, or ornamentation) and has adequate clearance around any doors or windows. For screens, make sure that any doors swing away from the screen. For retractable awnings, make sure the awning can extend its full projection without running into a tree, patio, roofline, or fence.
Types of Awnings There are several types of awnings you can use on your home. There are different styles for all uses around your home. You will find the higher end Sunbrella Fabric Awnings, may cost a bit more to purchase, but in the long run they last so much longer they will actually cost you less per year. Lets take a look at the different types and styles of awnings. Retractable Patio Awnings used to be seen only on upscale homes. Now they are more affordable and can last for years without needing any maintenance. These Retractable Awnings can be easily retracted or extended with a hand crank or motor. Motors are available with remotes and wind sensors that will retract the awning automatically in case a sudden storm comes and the awning was left extended. They are also great for outdoor entertaining and will keep any large slider or French doors shaded so your home stays cooler.
One important note for drop screens: not every manufacturer has a do-it-yourself style, so make sure you dont need a contractor before ordering the screen. A retractable awning installation is slightly more complicated than a screen installation, so follow the manufacturers instructions:1. Locate the bricks, rafters, studs, or joists to which to mount the awning.2. Install a pressure-treated board at the install location if mounting onto siding. It is extremely important that the awning be mounted on a flat, level surface, which isnt always possible with siding, shingles, and brick. 3. Install the mounting brackets, with the end brackets about three inches inside the edge of the awning and the other brackets evenly spaced between them. The number of mounting brackets depends on the width and projection of the specific retractable awning. 4. Install and attach the optional hood about 1 inch above awning location. 5. Lift the retractable awning, and insert it in the mounting brackets.6. Tighten the retaining bolts.
How easy an awning is to maintain depends a lot on how it is made, and there are differences between retractable awnings. The fabric on low-quality awnings, particularly cheaper fabrics like canvas and vinyl, is the component most vulnerable to damage: rotting or mildew from rain and humidity, sun exposure, frayed seams, cracking, and fading. Quality retractable awning companies use solution-dyed acrylic, a chemical fiber with the color embedded into it. Solution-dyed acrylic is a woven fabric, so it dries quickly, avoiding mold or mildew. Since is a synthetic fiber, it doesnt rot. And, since the color is part of the fiber itself, it lasts as long as 15 years before being replaced.