Sonya Awning April 23rd, 2018 - 11:39:17
How much shade coverage is required. What the width of the awning should be, based on the shade area. Add at least 12 inches to maximize coverage for sun and rain protection. How far out the awning extends (the projection), based on the shade area. There is a natural slope to an awning, so the actual shade is several inches shorter than the full projection. How high to mount the awning. Because of the awnings slope, the front of the awning is lower than the mounting position; this difference is the drop. The recommended drop is 3 inches per foot of projection. So, if the awning has a 12-foot projection, the drop is about 36 inches. To get a 7-foot clearance under the front bar, the awning has to be mounted at least 10 feet high. Scout out a mounting place that is free of obstructions (no lights, gutters, wiring, or ornamentation) and has adequate clearance around any doors or windows. For screens, make sure that any doors swing away from the screen. For retractable awnings, make sure the awning can extend its full projection without running into a tree, patio, roofline, or fence.
Why is the awning being used? Figure out clearly why that area needs protection and what element you want to control. The requirements for the awning are different for rain protection and sun protection. For example, to use the awning in wet areas, have at least a 3 inch slope, or pitch, to the awning per foot of extension. If an awning extends 12 feet, the pitch should be 36 inches, meaning that the awning must be mounted 3 feet higher than the height at the end of the awning fully extended. Awnings in sunny locations with little can be nearly flat. For other situations, awnings may not be ideal; high, sustained winds can seriously damage awnings, as can the weight from snow, ice, and hail. Accessories like wind or motion sensors can also be used to protect the retractable awning in less than ideal conditions.
Energy saving: The result of installing awnings should be reflected in the power bill. A good awning can save 100 hours of energy consumption per month. However, you need to plan and install the awnings properly so that the system provides you with adequate heat protection. Home decoration: The awning should look nice on the walls; thats perhaps the most important quality of an awning. Consult a designer or architect and make sure to know what color combination and style would look aesthetically correct on the walls of your home. Durable: This is a quality all consumers look in whatever they use! To make utmost use of the awning, go for retractable ones. They can be pulled back when the weather is harsh and thus you can ensure a longer life of your awning.
One important note for drop screens: not every manufacturer has a do-it-yourself style, so make sure you dont need a contractor before ordering the screen. A retractable awning installation is slightly more complicated than a screen installation, so follow the manufacturers instructions:1. Locate the bricks, rafters, studs, or joists to which to mount the awning.2. Install a pressure-treated board at the install location if mounting onto siding. It is extremely important that the awning be mounted on a flat, level surface, which isnt always possible with siding, shingles, and brick. 3. Install the mounting brackets, with the end brackets about three inches inside the edge of the awning and the other brackets evenly spaced between them. The number of mounting brackets depends on the width and projection of the specific retractable awning. 4. Install and attach the optional hood about 1 inch above awning location. 5. Lift the retractable awning, and insert it in the mounting brackets.6. Tighten the retaining bolts.