Sonya Awning April 06th, 2018 - 13:23:17
How much shade coverage is required. What the width of the awning should be, based on the shade area. Add at least 12 inches to maximize coverage for sun and rain protection. How far out the awning extends (the projection), based on the shade area. There is a natural slope to an awning, so the actual shade is several inches shorter than the full projection. How high to mount the awning. Because of the awnings slope, the front of the awning is lower than the mounting position; this difference is the drop. The recommended drop is 3 inches per foot of projection. So, if the awning has a 12-foot projection, the drop is about 36 inches. To get a 7-foot clearance under the front bar, the awning has to be mounted at least 10 feet high. Scout out a mounting place that is free of obstructions (no lights, gutters, wiring, or ornamentation) and has adequate clearance around any doors or windows. For screens, make sure that any doors swing away from the screen. For retractable awnings, make sure the awning can extend its full projection without running into a tree, patio, roofline, or fence.
Retractable awnings are getting attention. From green initiatives to historical renovations to downtown retail centers, property owners are hearing that retractable awnings are a terrific, inexpensive method to save money on energy and create a striking exterior feature. The rise in popularity for retractable awnings in the US means that there is a flood of new retractable awning options available, both in new styles and in new companies. Its tempting to look for the best deal alone, but there is such a variance in quality that customers can end up losing much more with short-lived and poor-performing awnings than they save upfront. It is possible to ascertain the quality of a retractable awning in a surprisingly succinct way: find out where it was made.
PVC - a hard polymer also used to make plumbing pipes; this tends to be brittle. Kevlar® - the polymer used to make bulletproof vests; Kevlar® straps in the arms instead of cables are extremely strong and durable and cant rust. Cables - braided metal strands which are used in the arms; these are usually steel, which rusts, leading the cables to discolor the fabric and eventually break. Cables cannot be replaced because they are internal to the arm and inaccessible. Terms: Installation Understanding a few terms about the positioning and installation of the awning can help determine the appropriate size and installation location for your awning: o Mount - what way or location the awning is affixed to the home or building, such as a wall mount, eave mount, soffit, or roof mount. Pitch - the angle that the awning comes down from the mount point to the front bar. Some lateral arm retractable awnings have an adjustable pitch. Projection - how far out from the wall the awning can extend. Load - the stress put on the awning, from wind, snow, even the weight of the awning itself (dead load). Good quality retractable awnings can sustain wind speeds up to approximately 35mph Pooling - water buildup on the canopy which can cause the fabric to sag and stretch.
Also, retractable awnings have financial benefits over fixed awnings that make them a tempting solution: Retractable awnings are overall less expensive than fixed awnings to install, and they dont require a contractor. Retractable awnings are about a quarter to a third of the cost of permanent construction to cover and utilize the same square footage. Because many styles of retractable awning arms are spring-loaded, there are no support posts to install, to block the view from under the awning, or to act as a potential hazard for children and pets. They require virtually no maintenance, not even mandatory cleaning.Capital Improvement Advantage Retractable awnings have interesting ways of saving a business money: o Direct energy cost savings. Sun protection systems cut heat buildup in a room as much as 77%, translating into a direct utility bill savings of up to 25%. "Dual use" as signage and promotion. Business names, logos, and telephone numbers can be printed on the awning, which saves money on constructing and designing separate signs.