Sonya Awning April 06th, 2018 - 13:29:43
PVC - a hard polymer also used to make plumbing pipes; this tends to be brittle. Kevlar® - the polymer used to make bulletproof vests; Kevlar® straps in the arms instead of cables are extremely strong and durable and cant rust. Cables - braided metal strands which are used in the arms; these are usually steel, which rusts, leading the cables to discolor the fabric and eventually break. Cables cannot be replaced because they are internal to the arm and inaccessible. Terms: Installation Understanding a few terms about the positioning and installation of the awning can help determine the appropriate size and installation location for your awning: o Mount - what way or location the awning is affixed to the home or building, such as a wall mount, eave mount, soffit, or roof mount. Pitch - the angle that the awning comes down from the mount point to the front bar. Some lateral arm retractable awnings have an adjustable pitch. Projection - how far out from the wall the awning can extend. Load - the stress put on the awning, from wind, snow, even the weight of the awning itself (dead load). Good quality retractable awnings can sustain wind speeds up to approximately 35mph Pooling - water buildup on the canopy which can cause the fabric to sag and stretch.
How much shade coverage is required. What the width of the awning should be, based on the shade area. Add at least 12 inches to maximize coverage for sun and rain protection. How far out the awning extends (the projection), based on the shade area. There is a natural slope to an awning, so the actual shade is several inches shorter than the full projection. How high to mount the awning. Because of the awnings slope, the front of the awning is lower than the mounting position; this difference is the drop. The recommended drop is 3 inches per foot of projection. So, if the awning has a 12-foot projection, the drop is about 36 inches. To get a 7-foot clearance under the front bar, the awning has to be mounted at least 10 feet high. Scout out a mounting place that is free of obstructions (no lights, gutters, wiring, or ornamentation) and has adequate clearance around any doors or windows. For screens, make sure that any doors swing away from the screen. For retractable awnings, make sure the awning can extend its full projection without running into a tree, patio, roofline, or fence.
o Canvas - a natural fiber (cotton) woven fabric; canvas awnings are prone to fade, mildew, and rot.o Solution-dyed acrylic - a man-made fiber which is woven into a lightweight, breathable fabric; because it is a chemical polymer, the fabric cannot rot. Solution-dyed means that the pigments are included in the fiber solution, which makes the fabric highly fade resistant. For the frame, the important materials are the body and joints: o Electrostatically powder-coated aluminum - a metal frame which is lightweight, durable, and rust-resistant; powder-coating is a method of applying pigment to aluminum frames which is extremely difficult to flake off or damage, unlike enamel or paint.
For a more thorough cleaning, use a soft-bristled brush and dish soap, working from the bottom up. If there is a persistent stain, mix a quarter cup of soap and a half cup of bleach in one gallon of lukewarm water, and soak the stain for 20 minutes, then rinse.There are some things to avoid when cleaning a retractable awning: Do not use a pressure cleaner, as it will damage the fabric. To prevent mold, mildew, or water stains, make sure that the awning is completely dry before closing it, unless there are high winds. Never use detergent on retractable awning fabric and avoid using the bleach-soap cleaner when possible. Most high quality retractable awning fabrics have several fabric treatments to prevent mildew and stains; harsh cleaners remove that treatment. Avoid heat. Some solution-dyed acrylic fabrics are heat-sensitive and can shrink in steam-cleaning, dryers, and hot water.