Sonya Awning April 29th, 2018 - 12:10:32
One important note for drop screens: not every manufacturer has a do-it-yourself style, so make sure you dont need a contractor before ordering the screen. A retractable awning installation is slightly more complicated than a screen installation, so follow the manufacturers instructions:1. Locate the bricks, rafters, studs, or joists to which to mount the awning.2. Install a pressure-treated board at the install location if mounting onto siding. It is extremely important that the awning be mounted on a flat, level surface, which isnt always possible with siding, shingles, and brick. 3. Install the mounting brackets, with the end brackets about three inches inside the edge of the awning and the other brackets evenly spaced between them. The number of mounting brackets depends on the width and projection of the specific retractable awning. 4. Install and attach the optional hood about 1 inch above awning location. 5. Lift the retractable awning, and insert it in the mounting brackets.6. Tighten the retaining bolts.
retractable and fixed awnings: Visibility. Many fixed awnings use stanchions or posts which can block the view; retractable awnings are suspended, either by springloaded arms or with guidewires, depending on the syste. Since they dont require external support, they allow uninterrupted views. Easy installation. Retractable awnings are very simply mounted onto the structure at points like a wall or beam without heavy labor or construction. Variety of use. Retractable awnings can go in small or special areas, such as over windows, where fixed canopies would not be appropriate. Changeability. Retractable awnings can move according to different weather conditions, such as changing the slope of the awning during rain, closing during storms, or using a series of awnings across a long outdoor area that follows the sunlight.
PVC - a hard polymer also used to make plumbing pipes; this tends to be brittle. Kevlar® - the polymer used to make bulletproof vests; Kevlar® straps in the arms instead of cables are extremely strong and durable and cant rust. Cables - braided metal strands which are used in the arms; these are usually steel, which rusts, leading the cables to discolor the fabric and eventually break. Cables cannot be replaced because they are internal to the arm and inaccessible. Terms: Installation Understanding a few terms about the positioning and installation of the awning can help determine the appropriate size and installation location for your awning: o Mount - what way or location the awning is affixed to the home or building, such as a wall mount, eave mount, soffit, or roof mount. Pitch - the angle that the awning comes down from the mount point to the front bar. Some lateral arm retractable awnings have an adjustable pitch. Projection - how far out from the wall the awning can extend. Load - the stress put on the awning, from wind, snow, even the weight of the awning itself (dead load). Good quality retractable awnings can sustain wind speeds up to approximately 35mph Pooling - water buildup on the canopy which can cause the fabric to sag and stretch.
Different Reasons for Using Awnings Various factors have come into play for why Europe has, for nearly a century, been consistently integrating retractable awnings into architectural plans. Many of the initial reasons were cultural; prevalent open air markets had contributed to a long history of fixed awning use, so it was a natural transition to easier to use and longer-lasting retractable awnings. More practically, though, the widespread use of retractable awnings comes down to cooling and energy efficiency. Europe has very high energy costs and, because of many old homes and flats, most residences do not have air-conditioning systems installed. Therefore, European homeowners have had an imperative to find inexpensive, effective cooling and efficiency products - and one of the most effective methods for controlling interior heat is retractable awnings.