Sonya Awning April 06th, 2018 - 13:32:06
One important note for drop screens: not every manufacturer has a do-it-yourself style, so make sure you dont need a contractor before ordering the screen. A retractable awning installation is slightly more complicated than a screen installation, so follow the manufacturers instructions:1. Locate the bricks, rafters, studs, or joists to which to mount the awning.2. Install a pressure-treated board at the install location if mounting onto siding. It is extremely important that the awning be mounted on a flat, level surface, which isnt always possible with siding, shingles, and brick. 3. Install the mounting brackets, with the end brackets about three inches inside the edge of the awning and the other brackets evenly spaced between them. The number of mounting brackets depends on the width and projection of the specific retractable awning. 4. Install and attach the optional hood about 1 inch above awning location. 5. Lift the retractable awning, and insert it in the mounting brackets.6. Tighten the retaining bolts.
Awnings have been common for more than 2000 years; retractable awnings have been around for almost 150 years. While the history of using awnings stretches far back in Europe and retractable awnings are commonly used there today, theyre rare in the United States - despite the fact that retractable awnings were invented in the US. This uneven adoption has led to an exposure of design options in Europe - intricate frames, new types of retractable frames, bold colors, and luscious patterns - while America, treating awnings as a practical afterthought, has stayed more conservative. A Quick History Some form of awnings has been around for millennia, starting in Egypt and the Middle East and spreading across the Roman Empire. Most of those were fixed canopies of mats, skins, or fabric bolts hung over poles. In the mid-1800s, shop owners began using movable awnings, which simply bunched up the fabric when it was taken down. In the latter part of the century, they began rolling awnings on a tube, cleanly retracting them and keeping the fabric safe. With minor variation, this is the same basic design used today on lateral arm retractable awnings.
UV rays, high wind, gusts, and rain - basically, normal weather - cause the most damage to awnings. Fading, molding, and tearing fabric. Twisting fixed frames from high wind damage or the weight of snow or pooling rain. In only two or three years, fixed awnings and canopies already show substantial wear, which is why the lifetime of most fixed awnings and canopies is only five or six years before the awning need to be replaced. Retractable awnings are closed when not in use, which cuts weather damage. That makes the maintenance much easier on retractable awnings compared to permanent awnings and canopies - there is no need to hunt down replacement parts, replace fabric every couple of years, or attempt to wrangle awnings down and into storage for winter.
For a more thorough cleaning, use a soft-bristled brush and dish soap, working from the bottom up. If there is a persistent stain, mix a quarter cup of soap and a half cup of bleach in one gallon of lukewarm water, and soak the stain for 20 minutes, then rinse.There are some things to avoid when cleaning a retractable awning: Do not use a pressure cleaner, as it will damage the fabric. To prevent mold, mildew, or water stains, make sure that the awning is completely dry before closing it, unless there are high winds. Never use detergent on retractable awning fabric and avoid using the bleach-soap cleaner when possible. Most high quality retractable awning fabrics have several fabric treatments to prevent mildew and stains; harsh cleaners remove that treatment. Avoid heat. Some solution-dyed acrylic fabrics are heat-sensitive and can shrink in steam-cleaning, dryers, and hot water.