Sonya Awning April 29th, 2018 - 11:12:33
Arms - the part of the frame which folds closed at the elbow when the awning is retracted (rolls in) and opens when the awning is extended (rolls out). Shoulder - the joints on the retractable awning arms where arms attach to the mounting bar. Front bar - the extrusion at the very front of the awning frame. Hood - a cover which fits over the retractable awning frame and fabric; when the awning is fully retracted, the hood protects the exposed fabric, frame, and motor from the elements. Valance - a strip of fabric, usually a few inches high, which hangs from the front bar of the retractable awning. Rib - the cross bars of the frame which support the awning fabric. Not every awning style has ribs, since ribs are often used to create a shape to the awning frame; for example, lateral arm retractable awnings dont have any ribs. Canopy - an elongated, dome, or waterfall style retractable awning.
How easy an awning is to maintain depends a lot on how it is made, and there are differences between retractable awnings. The fabric on low-quality awnings, particularly cheaper fabrics like canvas and vinyl, is the component most vulnerable to damage: rotting or mildew from rain and humidity, sun exposure, frayed seams, cracking, and fading. Quality retractable awning companies use solution-dyed acrylic, a chemical fiber with the color embedded into it. Solution-dyed acrylic is a woven fabric, so it dries quickly, avoiding mold or mildew. Since is a synthetic fiber, it doesnt rot. And, since the color is part of the fiber itself, it lasts as long as 15 years before being replaced.
One important note for drop screens: not every manufacturer has a do-it-yourself style, so make sure you dont need a contractor before ordering the screen. A retractable awning installation is slightly more complicated than a screen installation, so follow the manufacturers instructions:1. Locate the bricks, rafters, studs, or joists to which to mount the awning.2. Install a pressure-treated board at the install location if mounting onto siding. It is extremely important that the awning be mounted on a flat, level surface, which isnt always possible with siding, shingles, and brick. 3. Install the mounting brackets, with the end brackets about three inches inside the edge of the awning and the other brackets evenly spaced between them. The number of mounting brackets depends on the width and projection of the specific retractable awning. 4. Install and attach the optional hood about 1 inch above awning location. 5. Lift the retractable awning, and insert it in the mounting brackets.6. Tighten the retaining bolts.
How much shade coverage is required. What the width of the awning should be, based on the shade area. Add at least 12 inches to maximize coverage for sun and rain protection. How far out the awning extends (the projection), based on the shade area. There is a natural slope to an awning, so the actual shade is several inches shorter than the full projection. How high to mount the awning. Because of the awnings slope, the front of the awning is lower than the mounting position; this difference is the drop. The recommended drop is 3 inches per foot of projection. So, if the awning has a 12-foot projection, the drop is about 36 inches. To get a 7-foot clearance under the front bar, the awning has to be mounted at least 10 feet high. Scout out a mounting place that is free of obstructions (no lights, gutters, wiring, or ornamentation) and has adequate clearance around any doors or windows. For screens, make sure that any doors swing away from the screen. For retractable awnings, make sure the awning can extend its full projection without running into a tree, patio, roofline, or fence.