Sonya Awning April 23rd, 2018 - 11:13:51
A drop screen usually enhances an existing structural feature, such as a door or window, or as panels to enclose a porch, lanai, or gazebo. A drop screen requires a sturdy beam to mount to and possibly a door frame or post to fix the side guides to. After finding the location, simply measure the width of the area from side to side on the interior of the frame (for an inside mount) and add for the width of the side guides if mounted outside the window frame. Then measure the height of the screen, going from the inside (or bottom) of the top frame to the bottom of the threshold for the height; for an outside mount, add the size of the headerbox and bottom rail to the height measurement. Finding an ideal retractable awning location has a few other factors to consider.
One important note for drop screens: not every manufacturer has a do-it-yourself style, so make sure you dont need a contractor before ordering the screen. A retractable awning installation is slightly more complicated than a screen installation, so follow the manufacturers instructions:1. Locate the bricks, rafters, studs, or joists to which to mount the awning.2. Install a pressure-treated board at the install location if mounting onto siding. It is extremely important that the awning be mounted on a flat, level surface, which isnt always possible with siding, shingles, and brick. 3. Install the mounting brackets, with the end brackets about three inches inside the edge of the awning and the other brackets evenly spaced between them. The number of mounting brackets depends on the width and projection of the specific retractable awning. 4. Install and attach the optional hood about 1 inch above awning location. 5. Lift the retractable awning, and insert it in the mounting brackets.6. Tighten the retaining bolts.
Arms - the part of the frame which folds closed at the elbow when the awning is retracted (rolls in) and opens when the awning is extended (rolls out). Shoulder - the joints on the retractable awning arms where arms attach to the mounting bar. Front bar - the extrusion at the very front of the awning frame. Hood - a cover which fits over the retractable awning frame and fabric; when the awning is fully retracted, the hood protects the exposed fabric, frame, and motor from the elements. Valance - a strip of fabric, usually a few inches high, which hangs from the front bar of the retractable awning. Rib - the cross bars of the frame which support the awning fabric. Not every awning style has ribs, since ribs are often used to create a shape to the awning frame; for example, lateral arm retractable awnings dont have any ribs. Canopy - an elongated, dome, or waterfall style retractable awning.
Different Reasons for Using Awnings Various factors have come into play for why Europe has, for nearly a century, been consistently integrating retractable awnings into architectural plans. Many of the initial reasons were cultural; prevalent open air markets had contributed to a long history of fixed awning use, so it was a natural transition to easier to use and longer-lasting retractable awnings. More practically, though, the widespread use of retractable awnings comes down to cooling and energy efficiency. Europe has very high energy costs and, because of many old homes and flats, most residences do not have air-conditioning systems installed. Therefore, European homeowners have had an imperative to find inexpensive, effective cooling and efficiency products - and one of the most effective methods for controlling interior heat is retractable awnings.