Sonya Awning April 29th, 2018 - 12:16:27
Installation in a Few Easy Steps The general installation process for both traditional retractable awnings and drop screens is pretty simple: attach the correct number of mounting brackets using the appropriate fixing and insert the torsion (square) bar. The simplicity of installing awnings is what makes them ideal for do-it-yourself weekend projects. The exact installation steps, naturally, vary depending on the awning being installed (so always read the manufacturers specific instructions!), but these are the general processes. For a drop screen:1. Assemble the screen itself, putting together the roller (called the headerbox), similar to an old-fashioned shade.2. Install the mounting brackets at the top and around the door frame or the beam of the gazebo or porch.3. Snap in the headerbox, making sure that the bottom rail of the screen is toward the inside of the room.4. If there are vertical side guides, measure and cut them according to the height of the opening, and then screw them in place and snap them in position with the headerbox. If there are guide wires, screw the bottom brackets into place, and attach the wires to the cassette. Be sure everything is level and plumb.
Why is the awning being used? Figure out clearly why that area needs protection and what element you want to control. The requirements for the awning are different for rain protection and sun protection. For example, to use the awning in wet areas, have at least a 3 inch slope, or pitch, to the awning per foot of extension. If an awning extends 12 feet, the pitch should be 36 inches, meaning that the awning must be mounted 3 feet higher than the height at the end of the awning fully extended. Awnings in sunny locations with little can be nearly flat. For other situations, awnings may not be ideal; high, sustained winds can seriously damage awnings, as can the weight from snow, ice, and hail. Accessories like wind or motion sensors can also be used to protect the retractable awning in less than ideal conditions.
PVC - a hard polymer also used to make plumbing pipes; this tends to be brittle. Kevlar® - the polymer used to make bulletproof vests; Kevlar® straps in the arms instead of cables are extremely strong and durable and cant rust. Cables - braided metal strands which are used in the arms; these are usually steel, which rusts, leading the cables to discolor the fabric and eventually break. Cables cannot be replaced because they are internal to the arm and inaccessible. Terms: Installation Understanding a few terms about the positioning and installation of the awning can help determine the appropriate size and installation location for your awning: o Mount - what way or location the awning is affixed to the home or building, such as a wall mount, eave mount, soffit, or roof mount. Pitch - the angle that the awning comes down from the mount point to the front bar. Some lateral arm retractable awnings have an adjustable pitch. Projection - how far out from the wall the awning can extend. Load - the stress put on the awning, from wind, snow, even the weight of the awning itself (dead load). Good quality retractable awnings can sustain wind speeds up to approximately 35mph Pooling - water buildup on the canopy which can cause the fabric to sag and stretch.
Retractable awnings are getting attention. From green initiatives to historical renovations to downtown retail centers, property owners are hearing that retractable awnings are a terrific, inexpensive method to save money on energy and create a striking exterior feature. The rise in popularity for retractable awnings in the US means that there is a flood of new retractable awning options available, both in new styles and in new companies. Its tempting to look for the best deal alone, but there is such a variance in quality that customers can end up losing much more with short-lived and poor-performing awnings than they save upfront. It is possible to ascertain the quality of a retractable awning in a surprisingly succinct way: find out where it was made.