Sonya Awning April 06th, 2018 - 13:18:32
Awnings are great additions on the outer walls of the premises. Apart from providing sufficient element protection, awnings add to the outlook of any premise. One needs to choose the color, style and pattern of the awnings in accordance with the exterior of the building. Modern awning companies offer a lot of color shades, styles, pattern, textures and type of fabrics to choose from. You can rest assured that all your requirements would be satisfied once you find a reputed awning manufacturer. However, before you start sketching the style of the awnings, it would be better to know about the basic two categories of awnings. Based on the places of use awnings can be broadly classified under two headings - Residential and Commercial.
PVC - a hard polymer also used to make plumbing pipes; this tends to be brittle. Kevlar® - the polymer used to make bulletproof vests; Kevlar® straps in the arms instead of cables are extremely strong and durable and cant rust. Cables - braided metal strands which are used in the arms; these are usually steel, which rusts, leading the cables to discolor the fabric and eventually break. Cables cannot be replaced because they are internal to the arm and inaccessible. Terms: Installation Understanding a few terms about the positioning and installation of the awning can help determine the appropriate size and installation location for your awning: o Mount - what way or location the awning is affixed to the home or building, such as a wall mount, eave mount, soffit, or roof mount. Pitch - the angle that the awning comes down from the mount point to the front bar. Some lateral arm retractable awnings have an adjustable pitch. Projection - how far out from the wall the awning can extend. Load - the stress put on the awning, from wind, snow, even the weight of the awning itself (dead load). Good quality retractable awnings can sustain wind speeds up to approximately 35mph Pooling - water buildup on the canopy which can cause the fabric to sag and stretch.
One important note for drop screens: not every manufacturer has a do-it-yourself style, so make sure you dont need a contractor before ordering the screen. A retractable awning installation is slightly more complicated than a screen installation, so follow the manufacturers instructions:1. Locate the bricks, rafters, studs, or joists to which to mount the awning.2. Install a pressure-treated board at the install location if mounting onto siding. It is extremely important that the awning be mounted on a flat, level surface, which isnt always possible with siding, shingles, and brick. 3. Install the mounting brackets, with the end brackets about three inches inside the edge of the awning and the other brackets evenly spaced between them. The number of mounting brackets depends on the width and projection of the specific retractable awning. 4. Install and attach the optional hood about 1 inch above awning location. 5. Lift the retractable awning, and insert it in the mounting brackets.6. Tighten the retaining bolts.
A drop screen usually enhances an existing structural feature, such as a door or window, or as panels to enclose a porch, lanai, or gazebo. A drop screen requires a sturdy beam to mount to and possibly a door frame or post to fix the side guides to. After finding the location, simply measure the width of the area from side to side on the interior of the frame (for an inside mount) and add for the width of the side guides if mounted outside the window frame. Then measure the height of the screen, going from the inside (or bottom) of the top frame to the bottom of the threshold for the height; for an outside mount, add the size of the headerbox and bottom rail to the height measurement. Finding an ideal retractable awning location has a few other factors to consider.