Sonya Awning April 06th, 2018 - 10:56:17
PVC - a hard polymer also used to make plumbing pipes; this tends to be brittle. Kevlar® - the polymer used to make bulletproof vests; Kevlar® straps in the arms instead of cables are extremely strong and durable and cant rust. Cables - braided metal strands which are used in the arms; these are usually steel, which rusts, leading the cables to discolor the fabric and eventually break. Cables cannot be replaced because they are internal to the arm and inaccessible. Terms: Installation Understanding a few terms about the positioning and installation of the awning can help determine the appropriate size and installation location for your awning: o Mount - what way or location the awning is affixed to the home or building, such as a wall mount, eave mount, soffit, or roof mount. Pitch - the angle that the awning comes down from the mount point to the front bar. Some lateral arm retractable awnings have an adjustable pitch. Projection - how far out from the wall the awning can extend. Load - the stress put on the awning, from wind, snow, even the weight of the awning itself (dead load). Good quality retractable awnings can sustain wind speeds up to approximately 35mph Pooling - water buildup on the canopy which can cause the fabric to sag and stretch.
Why is the awning being used? Figure out clearly why that area needs protection and what element you want to control. The requirements for the awning are different for rain protection and sun protection. For example, to use the awning in wet areas, have at least a 3 inch slope, or pitch, to the awning per foot of extension. If an awning extends 12 feet, the pitch should be 36 inches, meaning that the awning must be mounted 3 feet higher than the height at the end of the awning fully extended. Awnings in sunny locations with little can be nearly flat. For other situations, awnings may not be ideal; high, sustained winds can seriously damage awnings, as can the weight from snow, ice, and hail. Accessories like wind or motion sensors can also be used to protect the retractable awning in less than ideal conditions.
For a more thorough cleaning, use a soft-bristled brush and dish soap, working from the bottom up. If there is a persistent stain, mix a quarter cup of soap and a half cup of bleach in one gallon of lukewarm water, and soak the stain for 20 minutes, then rinse.There are some things to avoid when cleaning a retractable awning: Do not use a pressure cleaner, as it will damage the fabric. To prevent mold, mildew, or water stains, make sure that the awning is completely dry before closing it, unless there are high winds. Never use detergent on retractable awning fabric and avoid using the bleach-soap cleaner when possible. Most high quality retractable awning fabrics have several fabric treatments to prevent mildew and stains; harsh cleaners remove that treatment. Avoid heat. Some solution-dyed acrylic fabrics are heat-sensitive and can shrink in steam-cleaning, dryers, and hot water.
Awning manufacturers have a shorthand jargon that succinctly describes their awnings characteristics, quality, function, even style. Knowledge is the key to having an efficient (and enjoyable) online shopping experience for retractable awnings. These simplified common terms can help you know in advance what youre looking at, so you know how to find what you want. Terms: Parts A lateral arm retractable awning is an awning which can be rolled up and closed; unlike fixed awnings and canopies, a retractable awning has no support posts. A retractable awning has an intrinsically simple design: o Frame - the skeleton of the awning; the frame is comprised of the mounting bar, arms, and roller tube. Mounting bar - the base of the retractable awning which is mounted in place; when the awning is retracted, the awning fabric rolls around the roller tube attached to the mounting bar.